The obstacle detection function is achieved by controlling the
current absorption and / or through the encoder connected to
the motors.
If the gate encounters an obstacle during the movement of
opening or closing, the obstacle detection function is activa-
ted and the operator reverses the direction of the gate.
In case of a second consecutive obstacle the operator stops
the gate right away and any further command is inhibited.
To re-enable the automation, you must remove power (and
disconnect batteries if present) or open the STOP contact input.
The Audio Alarm output will be active until this “reset”.
7. At the point where you want the slowdown to start give an
OPEN A command with the push button or the remote that
is already stored in memory. Leaf 2 starts to slow down and
stops when it reaches the mechanical stop or FCA2.
8. Leaf 2 starts to close at the set speed (trimmer speed).
9. At the point where you want the slowdown to start give an
OPEN A command with the push button or the remote that
is already stored in memory. The leaf 2 starts to slow down
and stops when it reaches the mechanical stop or FCC2.
10. Leaf 1 starts to close at the set speed (trimmer speed).
11. At the point where you want the slowdown to start give an
OPEN A command with the push button or the remote that
is already stored in memory. Leaf 1 starts to slow down and
stops when it reaches the mechanical stop or FCC1.
12. The manual time learning procedure is complete.
After time learning test the gate to set the force, speed and
sensitivity using the trimmers.
15
15/32
”
6 7/32”
17
15/32
”
The E024U board is supplied on a panel that fits in a 16x14”
enclosure.
8. ENCLOSURE
1. Apply resistance to the gate and adjust the Force to
make sure that the operator creates enough thrust to
reliably move the leaf.
2. Set the desired speed. Keep the speed relatively low on
big and heavier gates.
3. After Force and Speed are set to the desired settings
adjust the Sensitivity so the gate reverses promptly after
hitting a rigid object.
4. After all the adjustments are done perform setup again.
This is a more detailed description of what happens after an
obstacle detection:
Gate opening, obstacle detected:
The gate reverses partially (for 3 sec.) and STOPS. After that the
gate is in a halfway position or completely closed.
If an open_A command is received, the gate tries to open
from the current position:
• If there is another obstacle detection: the gate stops com-
pletely, the alarm goes off
• If the gate reaches the open position: the obstructions
count is reset, the gate returns to normal operations
Gate closing, obstacle detected:
The gate reverses partially (for 3 sec.) and STOPS. After that the
gate is in a halfway position or completely open.
If an open_A command is received in NON Automatic mode
• if the gate was not completely open: execute an open
• if the gate was completely open: execute a close
If an open_A command is received in Automatic mode:
• if the gate was not completely open: execute an open,
wait for the pause time and then closes.
• if the gate was completely open: reload the pausetime,
and then closes
If there is another obstacle detection: the gate stops comple-
tely, the alarm goes off.
If the gate reaches the close position: the obstructions count is
reset, the gate returns to normal operations
7. OBSTACLE DETECTION
23