950N 15
732773 - Rev. B
Master Slave
Master Slave
ENGLISH
8.2 APPLICATION WITH 2-LEAF DOOR (MASTER AND SLAVE )
The 2-LEAF function makes it possible to manage two opposing doors with synchronised movements and set (not
modifiable) delay angles.
The leaf controlled by the master automated system (see fig. 7 ) is the first to start opening and, when it has reached
the opening angle set for the leaf delay, the slave will also begin its movement. In the same way, when closing, the
master will start moving only when the slave has reached the closing angle set for the leaf delay.
Detection of an obstacle by one of the two automated systems causes immediate reversal of both.
The partial opening function makes it possible to control total opening only of the master.
The operating functions must be set only on the master automated system (or on the KP-Controller connected to it).
1.
Connect the 950I/O board of the two automated systems as shown in fig. 8 .
2. Connect all the sensors and pulse transmitters only to the master.
3.
Programme the following functions (see advanced prog.):
• “2-Leaf” active on both doors;
• select “MASTER” for the door that must start the opening movement first and “SLAVE” for the other;
•
set the same motion parameters on both automated systems;
• if you wish to disconnect the KP-Controller from the slave door, the function “MAINTAIN SETTINGS” must be set
to ON;
NOTE: the set-up must be carried out independently
Fig.7
Fig.8
Summary of Contents for KP CONTROLLER
Page 1: ...KP CONTROLLER q q OK ...
Page 17: ......
