1 0
1 1
1 2
B614 20
732998 - Rev.A
19
50 Nm
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
5.3 INSTALLING THE BARRIER BODY
RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
Carry out the work with the power supply discon-
nected.
!
Before you start, make sure that the plinth's concrete
has solidified.
In this phase the barrier must be locked.
Never manage the barrier by holding the board holder.
1. (
) Remove the 4 nuts with washers from the
plate
2. (
) Place the barrier body on the foundation, at
the four fixing points.
!
Be careful not to damage the electrical cable tubes.
3. (
) Fix the body of the barrier in post ion using
a nut with washer on every fixing point of the
foundation.
!
Use the torque wrench to tighten to the torque shown
in the figure.
