8
9
B614 19
732998 - Rev.A
22 mm
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
5.2 INSTALLING THE FOUNDATION PLATE
RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
Carry out the work with the power supply discon-
nected.
!
The barrier must be installed with the base plate
- The foundation schematic appended to this manual
gives the characteristics of the foundation as pure
approximations. The schematic considers the barrier
applied to the maximum limits indicated in this
manual and under the most arduous conditions. The
installation engineer is responsible for the evaluation
of the foundation materials and dimensions on the
basis of the characteristics of the ground and place
of installation. Perform structural calculations
where necessary.
1. Make the hole in the ground. Fill it with concrete,
allowing the cable conduits to protrude.
2. (
) Assemble the base plate.
3. (
) Immerse the base plate in the foundation
leaving the surface exposed.
!
The plate must be in the centre of the plinth.
The hole for the cables to pass through must corre-
spond with the orientation planned for the barrier
(barrier side, door side).
The cable conduits must protrude from the hole in the
plate by approximately 20 cm.
Check the plate is horizontal using a spirit level.
Clean the concrete off the surface of the plate and
the nuts with washers so they can be removed when
necessary.
4. Wait for the concrete to set.
B614 door
side
beam side
