FAAC 950N, Manual

Page: 17 / 30

950N 16
732708
- Rev. F
950 MPS
ENGLISH
6 PROGRAMMING THE 950 MPS BOARD
DS1 950 MPS SETTING
N° FUNCTION OFF ON NOTE
1
Final closing stroke Disabled Enabled
In the closed door position, it al-
lows the door to be kept constantly
pressurised via the motor. (do not
enable if push and go is ON)
2
Set-up procedure
Articulated arm and/
or openings up
to 90°
Sliding arm and/
or openings
greater than 90°
3 External selector switch in
position 2
Position 2
set on
Manual
Position 2
set on
Night
Allows to decide which mode is to
be associated to position 2 of the
external selector switch
4
Push and go Disabled Enabled
Set the outer selector switch to
position 0 (automatic) and push
or pull the door to open it. (do not
enable if the final closing stroke is
ON)
5 Leaf delay at opening
(master/slave application)
Disabled Enabled
6 Special automatic function
(Not available in the master
and slave application)
Disabled Enabled When in automatic mode, if this
parameter is enabled, the motor
will not prevent manual opening.
7 Not used
8 SCP
(Selectable Close Powe-
ring)
Additional force before
closing
NOTE: With dip switch 9
set to OFF, this function is
never active
Disabled Enabled
When this function is enabled, it
reduces the sensitivity of the
electronic anti-crushing device.
The activation of this function is
useful whenever high friction,
particularly hard door gaskets or
electric locks with difficult latching
are present.
9
FAILSAFE
(safety devices test as per
EN 16005)
LOW ENERGY
(low energy operation as
required by EN 16005)
FAILSAFE TEST
NOT ACTIVE
LOW ENERGY
ACTIVE
FAILSAFE TEST
ACTIVE
LOW ENERGY
NOT ACTIVE
If set to the ON position, dip sw
9 selects the activation of the
opening/closing function test of the
safety sensors.
If set to the OFF position, the
sensor test is disabled and the
movement of leaf can be set in the
“Low energy” mode as required by
Standard EN 16005.
When dip switch 9 is ON, the “inter-
lock” function and the gong are no
longer available.
10 Board updating using the
RS232 port Disabled Enabled
Allows enabling of the RS232
port for connection with the PC to
perform firmware updates.
Fig.4