4
PROGRAMMER FOR SLHP DECODER
Connections
Make the connections as shown in the drawing.
Â
When the programmer is connected to the
external power supply, it powers the Decoder
but not the receiver Plus868 (if present)
connected to the Decoder.
Â
When the Decoder is powered (e.g. inserted in
the rapid connector or connected by means of
a terminal board to a powered equipment), it
powers the programmer and receiver Plus868
connected (if present).
Switch on/Stand-by
When switched on, the display shows, in rapid
succession,
FAAC
and
Vx.x
(S/W version) after which
a sliding luminous point appears to indicate the
“stand-by” status.
In this status:
- if the programmer is connected to a decoder in
operation, it shows the Tx No. activated (if, apart
from the Tx No., four points appear, it means the Tx
is disabled);
- connection to the PC is possible.
Programming
Press PROG:
----
(request for password) is displayed;
Press
6
:
0000
is displayed;
If no password has been inserted in the decoder,
press OK; or press
6
to select each digit, make
the settings using keys
8
and
2
and press OK;
P 1
is displayed: use keys
8
and
2
to select the
required function;
Press OK and follow the explanation of the function
selected.
To quit the program at any moment, press PROG
till you return to stand-by status.
Â
Functions
P6
,
P9
,
P12
are not protected by
password: this means that they are operative
even without knowing the password, if any, set
on the Decoder.
Â
Functions
P6
,
P9
do not require the Decoder to
be connected: this means they are operative
also without the Decoder.
Data entry
When, within a function, you are requested to enter
a value (e.g. code or a Tx No.), press
6
to select
each digit, make the settings using keys
8
and
2
and press OK.
Â
Some values may be in alphanumeric form: this
means, for each digit, apart from numbers
0
to
9
, letters from
A
to
F
can also be set.
Â
Some values may be composed of more than 4
digits (display limit) and are “split” into two
successive displays: after the first part has been
set, press OK to set the second part.
J3
J2
J1
NC
NO
CO
M
J4
LED
PROG
OK
12
24 V
dc
RS232
햲
햳
RADIOCODER
SLHP DECODER
Tx SLH
MEX1
MEX2
2.1mm
+ internal
PC
ENGLISH
ENGLISH
