P a g e
|
12
Inserting the SIM card
Power Connections
Perform a final check of wiring and ensure the antenna is connected before switching on the
power. Once the power is switched on, the power LED should illuminate.
Exit Button (PTE)
When the exit button is pressed it will trigger relay 1 for the pre-programmed time in the app. (Default is 1 second)
Please ensure the SIM card is a 4G NANO SIM card. Do not use a SIM
card for a tablet, as these only support data, and do not support voice
and SMS. You simply require a mobile phone type SIM card. If using a
different sim card from the one provided refer to the Cellular Coverage
/ APN section at the end of this document (Pages 34
– 35)
It is always good practice to check if the SIM is active by putting it
into a phone and making a call.
24V dc
preferred
28V ac
absolute max!
Door/gate limit switch
(to allow remote checking
of door position)
Push to exit button
(triggers relay 1)
Pre-wired to
internal call button
24v
0v
D
e
te
c
t
Op
e
n
WARNING
Ensure power is OFF. Do not hot
insert or remove while power on
.
Insert chamfered
edge first.
Ensure SIM is activated.
Pre-pay SIM will need credit first.
Power connection
from 24v OUT on
Surge board
**Refer to Page 8**
Summary of Contents for 4400
