3
A
B
C
4
0
/
6
0
α
°
X
Fig. 3
Fig. 6
Fig. 4
Fig. 5
3. ELECTRICAL EQUIPMENT (standards system)
4. INSTALLATION OF AUTOMATION
4.1.
PRELIMINARY CHECKS
To ensure safety and an efficient automation, make sure the
following requirements are met:
•
The gate structure must be suitable for automation. In
particular, make sure it is sufficiently sturdy and rigid, and
that its dimensions are in line with those indicated in the
technical specifications.
•
Make sure that the leaves move properly and uniformly,
without any irregular friction during their entire travel.
•
Check if hinges are in good condition.
•
Make sure the travel limit mechanical stops are present.
•
We advise you to carry out any metalwork jobs before
installing the automation.
4.2.
INSTALLATION DIMENSIONS
Establish the installation position of the operator by consulting Fig.
4-5-6.
4.2.1. RECOMMENDED DIMENSIONS FOR INWARD OPENING
4.2.2. RECOMMENDED DIMENSIONS FOR OUTWARD OPENING
1)
Operators mod. 390
2)
Photocells
3)
Electronic equipment
4)
Key-operated push-button
5)
Radio receiver
6)
Flashlight
Notes: 1)
To lay electrical cables, use adequate rigid and/
or flexible tubes.
2)
Always separate low voltage accessories from
those operating at 230V~. To avoid any
interference, always use separate sheaths.
•measurements in mm
•measurements in mm
•measurements in mm
A
B
C (max)
60÷110
110÷130
730
90°
110÷160
110÷130
720
90°
160÷210
110÷130
710
90°
210÷260
110÷130
700
90°
260÷310
110÷130
690
90°
310÷360
110÷130
670
90°
60÷110
190÷210
650
120°
110÷160
230÷250
600
120°
160÷210
290÷310
540
120°
210÷260
310÷330
510
120°
α
α
α
α
α
A
B
C (max)
60÷110
110÷130
430
90°
110÷160
110÷130
380
90°
160÷210
110÷130
330
90°
210÷260
110÷130
280
90°
260÷310
110÷130
240
90°
α
α
α
α
α
C
B
A
α
°
4
0
/
6
0
~
2
0
0
~
4
1
Notes:
As for 120° openings the curved arm must be fixed
to the hole marked with the letter
X
