F2 E-FINNE, Manual, Page: 11 / 15

11
Preparation (Fig. B)
Cover (a)
Propeller (b)
Motor (c)
Housing (d)
Circuit board (e)
Battery (f)
Note: Do not open the E-Fin yourself, but
leave necessary work to qualified specia -
lists or contact the service hotline.
Note: Before using the E-Fin for the first
time, the battery must first be connected
to the motor to be able to operate the
E-Fin.
1. Unscrew the housing (d) by loosening
the screw (e) on the back.
2. Connect the two cable ends (f) to each
other.
3. Screw the two parts of the cable con-
nector together.
4. Reconnect the now connected housing
parts and secure them with the screw
(e).
Assembly (Fig. C–G)
Note: the product is not compatible with
carbon-reinforced SUP boards and sink-
ers, as this can lead to radio interference.
Turn the SUP board so that the fin box is
pointing upwards.
Plug-in fin mount (Fig. C)
Slide the e-fin (1) into the fin box of the
SUP board and secure it with the locking
pin (7).
US fin box (Fig. D)
1. Remove the fin plate and screw from
your SUP board.
2. Place the washer (9) in the fin box.
3. Slide the adapter plate (6) into the fin
box.
Note: make sure that the hole in the
adapter plate is positioned exactly above
the washer so that the adapter plate can
be fixed in place with the screw (10).
4. Fasten the adapter plate with the screw.
5. Slide the e-fin (1) into the adapter plate
and secure it with the locking pin (7).
EN
Attaching the antenna to the SUP
board (Fig. E)
1. Attach the fastener (1g) to a suitable
place on your SUP board (e.g. on the
rear D-ring).
2. Connect the antenna (1d) to the fas-
tener.
Fastening the remote control to the
paddle (Fig. F)
Note: the remote control (3) is pre-mount-
ed on the paddle holder (4) on delivery.
Attach the paddle holder with the remote
control to the paddle and secure it with
the clamp (4a).
Note: the remote control is attached to
the paddle at about handle height. It must
be mounted parallel to the paddle surface
and point towards the rider.
Attaching the remote control to the
wrist strap (Fig. G)
Note: you can also use the remote control
(3) with the wrist strap (8) instead of the
paddle holder (4).
1. Hold the two buttons (4b) of the paddle
holder together and pull the remote
control from the paddle holder.
2. Attach the remote control to the wrist
strap.
E
F G