ATR833A-II / P/N 833-II (Axxx)-(Axxx)
Operation and Installation
35
Doc.-No. 01.143A.010.71e / Revision 1.00
3.11 Master Reset
– Reset to Factory Settings
With following procedure all configurations are reset to the factory
settings. Switch of the device. Press MEM button and DW button and
switch the unit on. Following screen appears after start-up:
Reset to defaults:
yes/NO
The master reset is activated by pushing the
SET
button. The reset
carried out by confirmation with the SET key and the radio restarts
automatically.
Reset to defaults:
yes/NO
3.12 Adapter Operation
If the ATR833A-II is operated with an adapter for an older cable set, this
adapter is automatically detected and the device is set into adapter
mode. In adapter mode, the following settings are made automatically:
1. PTT Select is set to "all mics" because with "single mic" setting it
might be that one microphone is not working. The "PTT Select"
selection is therefore hidden in adapter mode.
2. Adjusting the volume of the sidetone during transmission is done
via the menu STL and controls both headphones. The menu item
STR is hidden. The intercom volume is adjusted via the INT setting
and controls both headsets.
