TOP
-ino
Operation Instructions
6 of
22
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D-69239 Neckarsteinach, Germany
Phone: +49 6229 7000, Fax: +49 6229 70067
E-mail: [email protected], Internet: http://www.fuddruck.de
2.5 Connecting the printer to
your PC
When connecting the cables please pay attention, that all
interface- and/or power cables are grounded properly and that
they are in accordance with the electronically regulations.
The interface connections are located on the back side of the
printer.
In order to connect the Centronics cable align the wide side of
the plug to the wide side of the printer socket. Afterwards
tighten the plug with the two screws in order to establish the
electrical contact in a stable way.
Then connect the cable to the computer (corresponding parallel
interface).
2.6 Printing a card from your
PC
The target is to print a card from your PC. For this you must
prepare the PC, that means install the software. Before printing
install the TOP-ino printer-driver. (diskette).Start your windows-
application to create a cardlayout (as a sample you can use
WINWORD from Microsoft). Make the following: Install the
windows-driver regarding to the installation manual.
1. Start the windows-application
2. Switch On the TOP-ino and wait for the initialisation (on the
LCD appears –printer ready-)
3. Print from the application (before set the TOP-ino printer in
the printer Setup)
4. Check the printed card.
2.7 Serial Interface
This serial interface is used for remote control.
Here it is possible to control and supervise the complete print
technical process by using a terminal (i.e. Win 3.11,
accessories, terminal, 9600 b/s or Win 95 with the
hyperterminal). The main functions are password secured.
