EZPull RXP-02 Sporting clays Receiver Setup Manual
Receiver LED Indicators
The receiver is equipped with Blue, Red and Yellow LED light
indicators.
1.
The Blue LED is normally on, but when the receiver senses
radio traffic, the Blue LED goes off causing the LED to appear
as if it is flashing. This is useful for troubleshooting.
2.
The Red LED is normally off and indicates the following:
2.1.
When a Target command is received, the Red LED turns
on momentarily.
2.2.
After each target release, the receiver checks the
battery condition. When the receiver detects a low
battery (LED ACID 12V battery), the Red LED flashes a
few times.
2.3.
When in Pairing mode (see below), the Red LED glows
steady.
3.
The Yellow LED is normally off It is used for timing setup
indications.
Pairing the Receiver with the Transmitter
Each shooting station requires a transmitter and receiver(s) on
the same unique address code.
To set the address on the transmitter, see the setup manual for
your specific EZPull model.
The RXP02 receiver is “Paired” with the EZPull on the desired
Trap number by simply pressing the specific Trap release key on
the transmitter.
1.
Ensure the receiver is powered up. A Blue LED should glow
steady. A flashing Blue indicates EZPull systems are being
used by neighboring shooting stations.
2.
To avoid mismatch with neighboring shooting stations,
ensure EZPull systems on other fields/stations are not being
used during this procedure.
3.
Locate the magnetic Pairing switch on the receiver. It looks
like a red bar on the side of the circuit board across from the
LED indicators.
4.
Hold a small magnet directly on top of the Pairing switch.
Blue and Red LEDs will start alternating. Keep holding the
magnet until only the Red LED glows steady and immediately
remove the magnet. The receiver is now waiting for a “call”
from a transmitter.
Notice: If you keep holding the magnet close to the pairing
switch after the Red LED goes steady, the system will enter
delay setup mode (see below).
5.
Press the respective target key on the EZPull transmitter. If
Paring is successful, the lights will flash rapidly and the
receiver will revert to normal operating mode.
6.
Press the target key on the EZPull transmitter again to verify
pairing. The Red target LED should glow momentarily.
7.
Troubleshooting Pairing:
7.1.
Blue and Yellow LEDs alternating – you held the magnet
too long and entered the timing setup mode. Remove
the magnet and then place it above the Pairing switch to
abort.
7.2.
If the Red LED remains steady, check that your
transmitter is working, or try with another transmitter.
7.3.
If the Red LED goes off without flashing rapidly, the
pairing failed, try again.
8.
To abort Pairing mode, place the magnet above the Pairing
switch and remove it at once, the Red LED will turn off and
the Blue LED will turn on.
