Page P-3
Repair and Service Manual
B
B
WEATHER PROTECTION
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
SPILT WINDSHIELD
(Ref. Fig. 2)
Tool List
Qty.
Plastic faced mallet ..................................................... 1
Wrench, 7/16".............................................................. 1
Phillips screwdriver...................................................... 1
Remove protective covering from the windshield (2)
(Ref. Fig. 2).
Install sash (3) on each side of the lower section of wind-
shield. Using a plastic faced mallet, gently tap sash to
ensure windshield seats properly (See Detail A).
Insert bolt (4) through washer (5), rubber grommet (6)
and existing hole in front strut. Secure with washer (5)
and lock nut (7) (See Detail B).
Do not over-tighten or
squeeze grommet
.
Place bottom section of windshield on rubber grommets
and press the sash, starting at the bottom, onto the front
strut so that it snaps into place (See Details B and C).
Repeat for opposite side of windshield.
Position top grips (8) as shown (See Detail D) at top
hole on each side of front strut. Secure with top grip fas-
teners (9).
Fig. 2 Split Windshield
Swing the top section of windshield up and secure by
hooking the top grip on each side of strut around the
windshield.
To secure windshield when lowered, press edge of wind-
shield firmly into windshield retainers (See Detail B).
Take care not to warp windshield when raising and lower-
ing the top section of windshield.
36
Strut
Rubber
Latch
Front of Vehicle
Windshield
Retainer
Strut
Front of
Vehicle
DETAIL D
DETAIL B
9
8
2
3
7
5
6
5
4
Windshield
DETAIL A
3
Windshield
Strut
DETAIL C
3
Summary of Contents for EXPRESS L6 2012
Page 6: ...Page iv Repair and Service Manual NOTES TABLE OF CONTENTS...
Page 201: ......
