ILL. 4
1
3
GENERAL OPERATING INSTRUCTIONS cont.
9.
IMPORTANT:
When disc is parked with blades resting on frozen ground, do not attempt to lift disc out of frozen ground by lowering
transport wheels. Lifting disc out of frozen ground with transport wheels may cause serious damage to disc components. Damage
will most likely occur to lift cylinder and rockshaft cylinder arm.
CAUTION: Always put all tractor controls in neutral, set the park brake and shut the engine off before servicing the disc.
If the tractor and disc were to roll, you could be seriously or fatally injured.
CAUTION: When trailing the disc over public roads, use the SMV emblem and warning lights for protection of tractor and
other motor vehicle operators. Check local laws for width and weight maximums.
CAUTION: When operating on hillsides, use extreme care. Tractor may tip sideways, if it strikes holes, ditch or other
irregularities.
10. SETTING DISCING DEPTH - See ILL. 4. To set discing depth lower disc into the ground while moving forward until disc reaches
desired discing depth. Install the necessary depth control stops, arrow 3, on lift cylinder shaft to maintain the desired cutting depth.
11.
IMPORTANT:
Before disconnecting hydraulic hoses from tractor, release pressure in hydraulic cylinders. Serious damage could
occur to hydraulic cylinder if oil expansion takes place due to warm weather or if disc is stored in heated building.
Page 10
REAR OF
DISC
FRAME
SMV
EMBLEM
CENTRE
OF
FRAME
