EZAutomation EZ Touch EZ7 Series, Quick Start Manual

Page: 14 / 32

13 / 31
4.3 M
OUNTING
I
NSTRUCTIONS
EZ7 comes in two parts:
1. HMI Processor Unit, mounted using 4 studs on backside of the control cabinet door
2. Display Unit, mounted on studs (number of studs depends on size).
A cable connects the two parts, which passes through a ¾” hole in the cabinet door.
To mount the unit, in summary:
•
Mark location of all holes
• Drill holes for the back and front unit mounting studs. (Please note that the mounting holes for
the back unit require countersink holes.
• Drill ¾” hole for the cable.
•
Connect display cable to the back side and mount the back side
• Thread the display cable through ¾” cable hole to the other side.
• Connect cable to front side and mount the front unit.
These steps are described below with pictures:
The EZ7 is stud mounted. All the necessary mounting hardware is provided with the unit. Both the
processor and the HMI screen have studs with nuts provided. Below is a full installation guide with
step by step instructions.
1. Use the provided screen with screw hole indicators to drill holes in your control cabinet.