7.
Hold
End Bracket
over the anchors or holes and secure to wall using correct screws. If using an electric
screwdriver or drill, use on low setting to make sure you do not over-tighten screw through the plastic.
8.
If you using another
End Bracket
, measure the same distance from the floor as the first
End Bracket
and
tape the Template on the wall. Make sure that all holes are level with the holes from the first
End Bracket
,
and repeat steps 5-9. It can be helpful to insert back tube into both Tube Receivers during this step.
9.
If you are attaching to a sidewall, measure the same distance from the floor as the
End Bracket
, and tape
punched-out Tube Receiver template to the wall. Be sure to check that Tube Receiver is
level
with the First
Tube Receiver
, not the
End Bracket
. It can be helpful to insert the back tube into both
Tube Receivers
during this step. Attach Tube Receiver to side wall as in step 5-9.
10.
Insert tubes into both
Tube Receivers
.
11.
Place Center Support so the tubes rest in the slots (preferably thicker part of tubes) & mark holes on back
wall.
12.
Attach Center Support (see 5-9 above
)
to back wall using anchors and screws.
Note
: Not all products
include Center Supports. Garage Shelves include two Center Supports. Extra Center Supports may be
purchased if needed.
Helpful Hints:
1.
Two shelves can be attached to each other by snapping a right Tube Bracket into one side of an End
Bracket and a left Tube Bracket into the other side of the same End Bracket and securing with included
nuts/bolts.
2.
For great looking corners, extend one shelf all the way to the wall, and mount an end bracket next to
the first shelf to begin your
second shelf.
Note: DO NOT
rest Center
Support on
tube extension
sleeves.
Left, Right: Joining two
shelves together with an
End Bracket
Below: Two shelves
make a corner with 1 End
Bracket
