\
4.
Use included nuts and bolts to secure Tube Receiver to the End Bracket.
Pop the bolt into the End Bracket hole on the outside of the End Bracket.
Flip the End Bracket over.
Wrap the nut around the bolt and turn it a few times with your finger.
Flip the End Bracket back over and use a screwdriver to screw in the bolt. The nut will begin to move
lower and lower on the bolt.
Important Note
: If installing into a tight space where tubes will be barely extended or not extended, insert ALL
tubes into both Tube Receivers during this step. The tubes will NOT fit into a tight space once the brackets are
mounted to the wall.
5.
Check for Studs
-
with 1 ¼” long nail/screw, push into the drywall to determine if you are hitting a stud. If
nail doesn’t go all the way you may be hitting a stud.
6.
Drywall- Screw in plastic anchors into drywall. If needed, drill a small “pilot” hole into the wall first. Use a
screwdriver or electric drill (on LOW speed – do NOT over tighten).
Note
: EZ Shelf will hold 200 lbs.
WITHOUT securing to studs.
If you hit a stud poking nail through drywall
,
do not use plastic anchors
- secure wood/metal screws
(not included) directly to stud.
For plaster walls – Do not use included plaster anchors/screws. Use plastic or lead anchors &
appropriate ¼” screws.
For Concrete walls – do not use included plaster anchors/screws. Use ¼” concrete anchors. You
will need to drill first (hammer drill is best).
Drywall Anchor & Screw Installation Diagrams
TAB should be
touching
against back of
wall
Large Holes
on Top
Anchor/Screw Hole
Left Tube Bracket –
has smaller tube
diameter than Right
1. Press Tip of
SnapSkru anchor
into Drywall using
screwdriver or
screw gun. Screw
anchor clockwise
into drywall until
anchor stops flush
with wall.
2. Place
item over
anchor &
insert
screw.
3.Tighten
screw
until flush
with item.
