601 North Congress Ave., Suite 606, Delray Beach, FL 33445
561-303-3615
Suggested Shelf Heights:
Single Hanging: 60-80” from floor to top of the shelf.
Double Hanging, 82-84” from floor for top shelf and 40-42” for bottom shelf.
Included Plastic Parts
2 Tube Receivers
(note right and left)
1 Center Support
End Bracket(s) (if
ordered)
Shelf with Rod Parts
Shelf Parts
For EZ Installation, read all instructions and watch installation videos BEFORE beginning installation.
Installation videos:
1.
Decide placement on back wall where shelf will end or two shelves will be joined. This is where you will
place your
End Bracket
. Find your End Bracket template and punch out along all dotted lines.
2.
Measure from the floor up (see suggested shelf heights above if needed), and tape the
End Bracket
template to the back wall. Make sure the template is level, and mark four screw holes with pencil.
3.
Snap the
Tube Receiver
into the appropriate side of the
End Bracket
. Hold End Bracket up to wall to
ensure that correct
Tube Receiver
is snapped in.
Note
: For proper
Tube Receiver
installation: Larger holes on the
Tube Receiver
MUST be on the top
AND the small, protruding plastic tab MUST face the back wall. (see photo on next page)
