2496251
2496251
2496251
2496251
Monster 6’ x 6’ Lacrosse Backstop Kit
Figure 1.
Assemble Side Panels
according to the diagram.
Note:
The corner loops on
each panel should face each other and the down tube
loops face back.
Figure 2.
Side Panel Assembly Lacing
Secure the 4 corners of the net, so it is easy to lace.
The labels should be on top. The lacing should be
snug. Start at the bottom in the middle of the
wiggle wire. Use the 15’ black ropes.
See Details Below.
1) B Corners, lace every square box.
2) C Side and Top, lace every other square box.
3) D Bottom, lace every square box.
Figure 3.
Bolting the Side Panels
If you have a Monster or EZGoal Lacrosse Net, the holes
are predrilled to secure the side panels.
If assembling to the 87615 and 87514 goals,
holes. Use eye bolts on the bottom two-holes.
See
Figure 3 (Details E & I).
Figure 4.
Backstop Top Net Connection
The thick black rope and label must be on top
(Detail F)
.
Locate the thin short rope corner ties, which can be found on the four
corners of the top net. Attach the top net to the 4 corner steel loops on
the backstop. Secure the heavy main rope on one panel to the steel
loop, pull tight and secure the main rope to the opposite side panel
(Detail G)
. Repeat for the bottom rope. Use the 5’ ropes to lace the top
net to the side panels
(Detail G).
Use the 15” rope to tie bow knots to
secure the top net to the goal in a few locations.
(Detail H)
.
Note:
Use a rubber mallet or block of wood if needed.
Page 4
03-85572 rev. 2017-08-15