2-3-2 USING THE SINGLE FUNCTION
To capture a single waveform or a noise effectively, do the following steps
1. Adjust the VOLTS/DIV and TIME/DIV to proper ranges.
2. Push the ACQUIRE button and choose Peak Detect On if you want to see the
peak value or Peak Detect Off if not.
3. Push the TRIGGER MENU button and select the signal slope.
4. Adjust the trigger level by using the TRIGGER LEVEL knob.
5. Push the SINGLE button on the top of the panel or select single mode in the
trigger mode menu. Then, you can see the single ready condition on the top
of the screen. "RUN" means ready condition, "STOP" means the end of
single capture.
If you want to set single ready condition again, only push the
SINGLE
button
or the
RUN/STOP
button.
57
Summary of Contents for DS-1000 Series
