- 13 -
ON
OFF
Hot surface
Caution
In case that over heat protector does not
recover
even after pressing reset switch,
the temperature in
the bath is still hot. For
preventing physical injury
and etc., do not
put your hands into the bath. Press
the
switch after the temperature falls.
※
When the overheat preventive unit is activated, the
power switch is ON but the display is off.
(1) Turn the power switch OFF.
(2) Confirm the suspected causes for the overheat
preventive unit to have activated (liquid amount is
sufficient or not, or the operating environmental
temperature is 35
℃
or below), make sure that the inside
of the bath has sufficiently cooled down and then press
the reset button of the overheat preventive unit.
(3) Turn the power switch ON.
(4) The display comes on again and temperature control
starts. (RUN lamp on)
※
If the temperature in the bath when the power is
turned on by turning the power switch ON after
resetting the overheat preventive unit, the heater
will be activated automatically (power outage
recovery mode) and you should take care for
possible burning or no-liquid heating.
※
If the over heat protector still works after
proceeding above-mentioned instructions,stop
operation immediately and call your
local dealer
or closest customer service center.
Recovery procedures
5-4 How to recover over heat protector
Power switch
Overheat preventive
unit reset button
