Vtracker/WitnessPro-2.0
www.eye3data.com
45
If switch/alarm/lock all set as ON, When sensor triggered, it will trigger alarm signal and event log, it will also trigger
alarm recording and event recording.
SET:
LOW (normal close) means low voltage can trigger alarm.
HIGH (normal open) means high voltage can trigger alarm.
ALARM:
Press ENTER to select between OFF or ON:
ON means when sensor triggered, alarm LED will flashing, until re-login the system with
account,
the flashing will disappear.
LOCK:
When LOCK is set ON, the video file will not be covered during the over-write process of hard
disk;
NEXT PAGE:
Sensor trigger action means to setup the alarm linkage for each sensor. For example, you setup the
ch1 as the alarm linkage for sensor1, when sensor1 is triggered, ch1 will change to full screen and the device will
response the trigger by PRI. Sensor1 has the highest priority, sensor8 has the lowest priority.
5.2 Sensor Output
WitnessPro/VTracker both support 2 sensor outputs, two sensor outputs are on the I/O HUB. All the alarm inputs can
trigger the three sensor outputs, such as sensor1~8, over speed, temperature, video loss and so on, please enter into
GUI>>>>SETUP>>>EVENT>>>SENSOR OUTPUT, as follows:
