iCAM100 Installation and Operating Manual
7
3
Installation
The iCAM100 is very simple to install and can either be secure directly to suitable
surface using the mounting holes on the module, or using the included wall
bracket
3.1
Wiring
Remove the iCAM100 lid by undoing the four screws (being careful not to loose
the washers).
Inside you will find a terminal block with four wires going to the camera unit, one
twisted pair for power to the camera & one twisted pair for the video signal.
Using a suitable cable feed through the gland connect the wires to the terminal
block as shown in the diagram.
Note:
For 3 wire Camera Modules the Black wire is common for
both the 0V Supply and the –Video Signal
Yellow & Black for composite output
Pink & Yellow for Differential output
Earth terminal for incoming earth on some models
Once the terminal wires have been connected, tighten the gland and replace the
lid accordingly.