QS-1
TPS150 Switching and Transmission System • Quick Start
Quick Start — TPS150 Switching
and Transmission System
Installation
Step 1
Turn off power to the input and output devices,
and remove the power cords from them.
Step 2
If desired, mount the TPT150 transmitter in a
rack.
Step 3
If desired, mount the TPR150 receiver using the
included projector bracket.
Step 4
Connect source video devices to the transmitter’s
inputs.
Inputs 1 and 2 —
Connect
two RGB video sources.
If desired, connect a
monitor to the Input 1 Local Monitor
connector.
Inputs 3 and 4 —
Connect either
component video,
S-video, or
composite video
sources.
For proper
system operation, connect only one video
format to input 3 and input 4.
Step 5
Connect audio devices to the input 1
through input 4 left and right RCA
connectors.
Step 6
Connect an audio device, such as powered
speakers, to this 3.8 mm, 5-pole captive screw
connector for balanced or unbalanced audio
output.
Step 7
Connect a host device, such as a computer or
touch panel control, to the transmitter via this
9-pin D connector and a null modem serial
port cable for serial RS-232 control.
Step 8
Connect an optional CTP150CM
control panel module or other
contact closure device to this 8-pin
3.5 mm captive screw connector.
See chapter 2, Installation.
To make your own contact closure
device, wire the connector as
shown at right. To issue a
command, momentarily short the
appropriate pin to ground.
Step 9
Connect a shielded twisted pair (STP) cable or
foil shielded pair (FTP) with RJ-45 connectors
between the transmitter and receiver. Ensure
that both ends of the cable are terminated using
the same protocol, either TIA/EIA 568 A or 568 B.
Extron recommends STP or FTP cable
only
.
Unbalanced Output
Tip
See caution
Sleeve
Tip
See caution
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
CAUTION
Connect the
sleeve to ground.
Connecting the
sleeve to a
negative (-)
terminal will
damage the audio
output circuits.
R-Y
B-Y
Y
VIDEO
S-VIDEO
L
R
Connected
RS-232
device pin Function
TPS150
pin
1
2
3
4
5
6
7
8
9
—
RX
TX
—
Gnd
—
—
—
—
Not used
Receive data
Transmit data
Not used
Signal ground
Not used
Not used
Not used
Not used
5
1
9
6
Female
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
CONTACT
CLOSURE
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
568 A
568 B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Clip Down
Side
1
1&2
3&6 4&5
7&8
2 3 4 5 6 7 8
RJ-45
connector
Twisted
Pairs
Blue
Blue
