A
(see figure 2 on the previous page) — shows the configuration and
connection status of the touchpanel:
•
Unlit during normal operation (the touchpanel is configured and connected to an
IP Link Pro control processor).
•
Blinks red if the touchpanel has been configured but is not connected to an IP Link Pro
control processor.
•
Permanently lit if the touchpanel has not been configured.
The indicator can be toggled between enabled and disabled, using the
B
— one LED light bar, above the screen, which can be programmed to provide
system feedback.
•
Light red or green
•
Blink or light continuously
For information about programming this light, see the
Global Configurator Help File
.
C
— monitors ambient light level and adjusts screen brightness, based
on the settings configured using the
D
— with a touch overlay. The touchpanel has a resolution
of 1280x800 (TLP Pro 1220 series), 1366x768 (TLP Pro 1520 series), or 1920x1080
(TLP Pro 1720 series).
E
— two speakers located below the screen, one on each side of the panel,
provide stereo audio for video preview and audible feedback from button presses.
F
— detects motion between three to five feet from the touchpanel, and at
least 15° from the center axis.
•
When no motion has been detected for a user-defined period of time, the touchpanel
enters sleep mode.
•
When motion is detected by the sensor, the screen display is restored and active.
G
(MG models only) — activates the setup menu and calibration screen (
). It is accessed from under the touchpanel.
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Panel Features
7
