Extron electronics TLI Pro 101, User Manual

Page: 37 / 41

Reference
Material
This section describes:
•
Network Port Requirements and Licensed Third-party Software Used by the
Touchpanels
•
Reset Modes
•
Secure Sockets Layer (SSL) Certificates
•
IEEE 802.1X Certificates
Network Port Requirements and Licensed Third-party Software Used
by the Touchpanels
For information about network port requirements and licensed third-party software for all the
touchpanels described in this guide, please refer to the
Pro Series Control Product Network
Ports and Licenses Guide
, which is available at www.extron.com .
Reset Modes
The TLI Pro 101 has three reset modes that are initiated by pressing the Reset button:
•
Use Factory Firmware
•
Reset All IP Settings
•
Reset to Factory Defaults
•
Enable or Disable the DHCP Client
The
Reset
button is found on the rear panel (see figure 2 ,
G
on page 5).
Use Factory Firmware
This mode is used to boot up the unit with factory-installed firmware for a single power cycle if
a firmware update fails or incompatibility issues arise with user-loaded firmware.
Activation
To start the Use Factory Firmware reset mode and replace firmware:
1. Remove power from the touchpanel.
2.
On the touchpanel, hold down the recessed Reset button (see figure 2 , G ) while
applying power to the unit. When power is restored, the Reset LED ( F ) lights. Hold the
Reset
button for a further two seconds before releasing it. The touchpanel enters factory
firmware mode.
3. Upload new firmware to the unit as desired (see Updating the Firmware on page 27).
NOTE:
Do not continue to operate the touchpanel using the factory firmware
version. If you want to use the factory default firmware, you must upload that
version again (see
Updating the Firmware ).
TLI Pro 101 • Reference Material 30