Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is
powered on in this mode. All user files and settings such as drivers, adjustments, and IP
settings are maintained.
NOTE:
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
Reset All IP Settings
This mode resets all IP settings to factory defaults.
Activation
To reset all IP settings:
1.
Hold down the
Reset
on page 5) for about 6 seconds until
the Reset LED (
) blinks twice (once at 3 seconds, again at 6 seconds).
2.
Release and press the
Reset
button momentarily (for <1 second) within 1 second.
Nothing happens if the momentary press does not occur within 1 second.
Result
•
Resets All IP Settings mode:
•
Sets the IP address back to factory default (
192.168.254.251
)
•
Sets the subnet mask back to factory default (
255.255.255.0
)
•
Sets the gateway address to the factory default (
0.0.0.0
)
•
Sets all other IP settings, addresses, and domain and host names back to factory default
•
Turns DHCP off
Reset to Factory Defaults
This mode resets all IP settings and touchpanel settings, including passwords, to factory
defaults and removes all configurations. It allows you to start over with configuration and
uploading.
NOTES:
•
The factory configured passwords for all accounts on this device have been set to the
device serial number. Passwords can be changed during configuration. They are case
sensitive.
•
If the device is reset to default settings, the passwords are reset to the default
password, which is
extron
(for either
admin
or
user
).
Activation
To reset the unit to all factory default settings:
1.
Hold down the
Reset
button for about 9 seconds until the Reset LED blinks three times
(once at 3 seconds, again at 6 seconds, again at 9 seconds).
2.
Release and press the
Reset
button momentarily (for <1 second) within 1 second.
Nothing happens if the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the
firmware).
•
Does everything Reset All IP Settings mode does.
•
Removes touchpanel user interface layout and configurations.
•
Resets all touchpanel settings to factory default.
TLI Pro 101 • Reference Material
31
Summary of Contents for TLI Pro 101
Page 7: ...TLI Pro 101 Contents vii ...
