3.
Click the
Connect
button (or
Cancel
to exit the program).
If you select Emulate, click on the
Work Offline
button (or
Cancel
to exit the program).
Figure 15.
“Connect to device?” Dialog Box — Emulate Mode
NOTE:
When Emulate/Work Offline is selected, the
Connect
button is replaced by
a
Work Offline
button. Instead of establishing a connection with the sound
processor, the program allows you to create a configuration that can be
saved as a file and used to update the configuration of the sound processor
when the program is in Live mode.
When the program opens, you may still toggle between Live or Emulate modes by using
the buttons in the top right corner of the program window, as described on page 23 in
“Live and Emulate Modes”
.
If you check the “Stop prompting me to connect upon startup” box, the next time the
program opens, this dialog box is not shown and the program automatically opens in
Emulate mode. Click the
Live
button in the program window to switch to Live mode.
To re-enable this box, use the menu system to navigate to
Options>Re-enable Dialogs
(see page 53). This clears the check box in all dialog boxes and all previously disabled
pop-up messages occur regularly again.
SSP 7.1 • Setup and Control Software
25