RGB-DVI 300 and RGB-HDMI 300 • Installation
2-5
Through-desk mounting
Mount the unit through a desk or podium using the optional
Extron MBD 129 through desk mounting kit (part # 70-077-02) as
follows:
1
.
Remove rubber feet if these have been attached.
2
.
Attach the brackets to the scaler, using the four 4-40 screws
provided; leave the screws slightly loose.
Through-desk mounting
3
.
Hold the unit in position, under the mounting surface.
Mark the location of the four screw holes and the
mounting hole to be cut in the table.
4
.
Remove the table material. Test the fit by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse file to enlarge the hole.
5
.
Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" deep (6.3 mm) deep.
6
.
Attach the brackets to the mounting surface, using the four
#8 wood screws provided with the kit.
7
.
Slide the device in or out until the front panel is flush with
the table surface. Tighten the screws installed in step 2.
8
.
If these screws are inaccessible to a screwdriver, mark the
location of the unit relative to the brackets, remove the unit
and brackets, tighten the screws, and replace the unit.
Summary of Contents for RGB to DVI Scaler RGB-DVI 300
