Quantum Ultra Series Videowall Processing Systems • Maintenance — Quantum Ultra 610 Only
92
2.
Pull the front door all the way down (see figure 85).
Figure 85.
Front Panel Door Open
3.
When finished with maintenance tasks, lift up the front panel door until it is in place.
4.
Holding the door closed, use a coin to rotate the lock clockwise until it is in a vertical
position.
The power supplies and fans can be removed and replaced while the system is powered
on. To replace the SBC and drives, the system must be powered off.
The items that may need to be replaced at some time during the lifetime of the
Quantum Ultra 610 are accessed via the front panel. Most of these items are held in place
by thumbscrews.
ATTENTION:
•
Thumbscrews should be tightened with a screwdriver after both initial installation
and subsequent access to the panel.
•
Les vis doivent être serrées avec un tournevis après la première installation et
l’accès postérieur au panneau.
NOTE:
The thumbscrews cannot be removed completely.
85
