Installing Transmitter and Receiver Boards into the Enclosure
Any combination of up to 16 single-slot or 8 double-slot transmitter or receiver boards can
be installed in the PowerCage enclosure. The quantity and type of boards varies depending
on the configuration for each installation site.
Before
installing the boards in the enclosure, refer to the model-specific guide for each
PowerCage transmitter and receiver board you are installing. Some boards have switches
that must be set before installation. The guides describe the features of each board and
how to set up and cable it.
NOTE:
The boards are hot-swappable; they can be installed or removed without turning
off or disconnecting the power to the PowerCage enclosure.
CAUTIONS:
ATTENTIONS :
•
Use ESD precautions when installing a board to avoid damaging it. Keep the
board in the anti-static bag until it is needed.
•
Prenez les précautions ESD lorsque vous installez une carte afin d’éviter de
l’endommager. Gardez la carte dans le sachet dépoussiérant jusqu’à ce que vous
en ayez besoin.
•
Use proper grounding techniques during installation.
•
Utilisez des techniques de mise à la terre correctes pendant l’installation.
NOTE:
The main power supply or redundant power supply boards should be installed
and not removed except during replacement. Power supply board removal and
replacement for testing purposes should be avoided or kept to a minimum.
1.
Where applicable, remove as many blank plates or previously installed boards from the
rear of the PowerCage Enclosure as necessary to accommodate the number of new
boards to be installed. Save the screws for use in step
3
.
PowerCage 1600 Enclosure • Installation
8