5
OCS 100W Parts
Pull
Cover
Body
Bracket
Cover
Wiring
Harness
Mounting
Bracket
Mounting Bolt,
Washer and Nut. (2)
Figure 6.
OCS 100W Parts
Installation
ATTENTION:
•
All structural steps and electrical installation must be performed by qualified personnel in accordance with local and
national building codes and electrical codes.
•
Toute étape structurelle et installation électrique doit être effectuée par un personnel qualifié, conformément aux codes
de sécurité de bâtiments et de produits électriques en vigueur à l’échelle régionale et nationale.
•
Only connect to Class III SELV systems.
•
Connectez l’unité uniquement à des systèmes fonctionnant en très basse tension de sécurité (TBTS) de classe III.
Pull
Cover
Body
Bracket
Cover
Wiring
Harness
Mounting
Bracket
Mounting Bolt,
Washer and nut. (2)
Insert wiring through
Mounting Bracket.
Wall
Building Wiring
1
“POP”
Snap sensor onto
mounting post.
5
“SNAP”
Push
Replace Cover.
7
Wall
Wiring
Harness
Secure Mounting
Bracket to the wall.
Connect building wiring to
Wiring Harness with included
wire nuts.
2
3
Position
Locking
Screw
Loosen Tighten
Plug Wiring Harness into connector located
on the left side, opposite exit slot and place
wiring under wire tabs. Align sensor and tighten
position locking screw.
6
32'
23'
32'
23'
40'
20'
40' - 0" Major Coverage
20' - 0" Minor Motion Coverage
10' - 0"
Mounting
Height
Sensory Coverage
US Minor Motion
US Major Motion
IR Minor Motion
IR Major Motion
Snap Bracket Cover in place to
conceal wiring and Mounting
Bracket.
4
Bracket
Cover
Figure 7.
OCS 100W Installation
6
7
