Extron electronics NAV E 101, User Manual

Page: 13 / 80

NAV E 501 and NAV E 101 Encoders • Installation and Basic Operation 5
Installation and
Basic Operation
This section describes the installation and the operation of the NAV E 501 and NAV E 101
encoders, including:
•
Mounting
• Rear Panel Connections and Features
• Front Panel Connection and Indicators
• Startup and Basic Operation
Mounting
If desired, mount the encoder in a rack (see Mounting the Encoder on page 70).
Rear Panel Connections and Features
NAV 1G/PoE+
HDMI LOOP THRU
POWER
12V
2.0 A MAX
L CONT
C T Tx Rx G S G
RS-232 IR R
AUDIO
LAN
CONTROL INPUT
NAV E 101
RESET
HDMI LOOP THRU
POWER
12V
2.0 A MAX
L CONT
C T Tx Rx G S G
5V/500 mA
RS-232 IR R
AUDIO
USB 2.0 CONTROL INPUT
NAV E 501
RESET
NAV 1G/PoE+ EXT
LAN
F F F H H H C C C A A A B B B D D D J J J E E E I I I G G G
Figure 2. NAV E 501 and NAV E 101 Rear Panel Connectors and Features
A
HDMI input port
F USB 2.0 port
(NAV E 501 only
)
B
Loop Thru port
G
NAV 1G/PoE+ port
C Audio input port (see page 6 ) H Extension port (NAV E 501 only )
D Contact Closure port I Reset button and LED
E Control port J Power connector
A
HDMI input port
— Connect an HDMI cable between this port and the
HDMI
HDMI output port (or DVI port, with an appropriate adapter) of the digital
video source. See
LockIt Lacing Brackets on page 7 to use the LockIt
HDMI Cable Lacing Bracket to secure the connector to the encoder.
B Loop Thru port — Connect a display to this female HDMI
LOOP THRU
connector for local loop-through monitoring of the source signal. See
LockIt Lacing Brackets .