MTP AV Series • Installation
4
Setting the Jumpers on New Generation Non AAP Models
1.
Remove and retain the four screws (two on each side of the unit) that secure the cover
to the MTP (see figure
1
).
SHAR
P
GAIN
Figure 1.
Removing the MTP Cover
2.
For the receiver
, slide the cover slightly forward to clear the front panel adjustment
knobs.
3.
Lift the cover straight up.
4.
If the transmitter or receiver is an audio unit
, remove and retain the two screws
that secure the audio board to the main (video) board (see figure
2
).
5.
Pull the audio board back until the audio connectors clear the back of the unit and lift
the board out of the way.
NOTE:
Step
4
and figure
2
are correct for either S-video or composite video models.
Transmitter Front Panel
Receiver Front Panel
Receiver Rear Panel
Transmitter Rear Panel
Remove these screws.
Figure 2.
Removing the Audio Board
Summary of Contents for MTP R AV
Page 6: ...MTP AV Series Contents vi...
