MGP Pro Series • Installation
9
RJ-45
Connector
Insert Twisted
Pair Wires
1 2 3 4 5 6 7 8
Pins:
Crossover Cable
Straight-through Cable
Pin
End 1
Wire Color
End 2
Wire Color
Pin
End 1
Wire Color
End 2
Wire Color
1
White-green
White-orange
1
White-orange
White-orange
2
Green
Orange
2
Orange
Orange
3
White-orange
White-green
3
White-green
White-green
4
Blue
Blue
4
Blue
Blue
5
White-blue
White-blue
5
White-blue
White-blue
6
Orange
Green
6
Green
Green
7
White-brown
White-brown
7
White-brown
White-brown
8
Brown
Brown
8
Brown
Brown
T568A
T568B
T568B
T568B
A cable that is wired as T568A at one
end and T568B at the other (Tx and Rx
pairs reversed) is a “crossover” cable.
A cable that is wired the same at both
ends is called a “straight-through” cable
because no pin or pair assignments are
swapped. Both ends of the cable can be
T568B (as shown) or T568A (not shown).
Figure 7.
Wiring the LAN Connector
If desired, configure the LAN port by using SIS commands (see the LAN port setup
commands, beginning with the
command
on page 68) or by using the
Comm./IP
Configuration
menu on the front panel (see
on page 29). The LAN port default settings are:
IP address:
192.168.254.254
Subnet mask:
255.255.0.0
Gateway IP address:
0.0.0.0
DHCP:
off
Reset button
on page 6) Pressing this
RESET
recessed button causes various IP functions and Ethernet connection
settings to be reset to the device defaults (see
on page 40 for
more information).
Reset LED
— This LED, located to the upper-right of the reset button, blinks a varying
number of times to indicate which reset mode has been entered (see
for
details).
BNC output connectors
— Plug an output device into these five BNC connectors, as
shown in figure 8.
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGBHV
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGBS
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGsB
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
HD Component Video
Figure 8.
Connecting to BNC Output Connectors
7
8
