Extron electronics IPI 101, User Manual

Page: 5 / 100

IPI 100 Series, IPI 200 Series • Quick Start Guide
QS-1
Quick Start Guide — IPI 101, IPI 104
W Installation and service must be performed by authorized
personnel only. These products must be used with UL
approved, grounded electrical boxes.
To install an Extron IP Intercom
®
Sytem, follow the steps below:
Step 1
Turn all of the equipment off and disconnect the power cords .
Step 2
Select the installation location and install an electrical wall box
for each IPI unit and MLC 226 IP in the system. See “Sample
Applications” on page 2-8 for ideas on designing an intercom system.
Step 3
Install button labels in each of the IPI’s buttons. See page 2-2 for
instructions.
Step 4
Mount each IPI into an AAP wallplate or device faceplate, as
described on page 2-4.
Step 5
Connect each IPI to an MLC 226 IP via the RJ-45 intercom ports,
using a standard CAT 5, CAT 5e, or CAT 6 straight through network
cable. See “IPI Rear Panel Features and Cabling“ on page 2-6.
HOST
CONTROL
R
1=DIGITAL I/O
2=Tx 3=Rx 5=GND
38400, N, 8, 1
PRESS TAB WITH
TWEEKER TO REMOVE
INTERCOM
A
UDIO OUT
LAN
IPI 101 AAP or IPI 104 AAP
Rear Panel
MLC 226 IP Rear Panel
<100’ (30.4 m)
Step 6
Cable each MLC 226 IP to other devices: connect the MLC’s LAN
port to the local network via a standard network cable with RJ-45
connector, and, if desired, cable the rear panel Audio connector
to speakers for local audio output. Cable other devices (control
modules, SCP, IR Emitters) to the MLC as needed.