Surface Access Products • Maintenance and Modifications
Surface Access Products • Maintenance and Modifications
Maintenance and Modifications, cont’d
Mounting
Surface
Clamshell
Full Thread
Mounting Bolts
AAP Cables
Flat Washer
IEC Power Cord
RJ-45 Connectors
Shroud
HSA 802
Remove 16
screws
12
5 -
50
/60
Hz
0.
5A
CO
MPU
TER
INP
UT
SEL
ECT
AU
DIO
Figure 3-3 — Removing the HSA 802 from the table
17
.
Carefully lower the HSA enclosure into the table opening.
From the underside, bolt the clamshell to the enclosure
with the two bolts removed in step
5
.
3-7
3-6
Figure 3-4 — Disconnecting the interior AC cable
18
.
Connect the IEC power cord and RJ-45 cables to the
connectors on the underside of the surface mount
enclosure.
19
.
To prevent wear and tear caused by cable movement,
secure the AAP cables underneath the table. See
Routing
the AAP Cables
in chapter 2,
Installation
.
Adding a Second Connector Panel
The standard HSA 800 includes one connector panel with the
associated connectors and AAP opening. Non-US/domestic
versions also have a separate AC connector panel. Future needs
may demand adding a second connector panel and, for non-
US/domestic versions, an AC panel (in effect converting the
HSA 800 into an HSA 802). Add the additional panels as
follows:
Ensure that AC power is disconnected before
servicing the HSA unit.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
