2.
Connect the cables to the receiver
(continued).
b.
Install any optional devices and connect their
cables to the appropriate ports on the receiver
base.
c.
If desired, set the Tone DIP switch on the
receiver base:
•
Up
: Enable the microphone volume
change alert tone (default).
•
Down
: Disable the microphone volume
change alert tone.
NOTE:
The Mix DIP switch should always
be set to Down. Leaving it in the Up
position could cause noise.
3.
Attach the receiver dome to the housing.
a.
Place the dome onto the housing, aligning the
arrow etched on the dome locking tab with
the raised arrow on the housing rim. The two
tabs in the housing should slide into the two
slots in the base.
Arrow on Housing
Arrow on Tab
Ü
Align the arrows on the housing rim and the
dome tab.
Arrow
Receiver
Dome
Twist to
Lock
Align Arrows
Arrow
Dot
Tab
Tab
Ö
Set the Tone and Mix DIP switches (optional).
O
N
1
2
CTS-2
O
N
12
CTS-2
MIX
TONE
RS-232
AU
X IN
CTC
+
OUT
IN
RL
Y
Tx
IN
Rx
C
NO
MIX
TONE
Base Plate
VoiceLift System with PVS 405D Installation Guide
•
Installation — Stage 4
30