Stage 1b — Installing the Receiver to a Junction Box
1. Install the junction box.
•
Install the junction or ceiling box (not included)
flush with the mounting surface (follow the
instructions provided with the junction box).
•
Use a one-gang plaster ring (Raco 772) if the
junction box is larger than one-gang.
WARNING:
Improper installation may result
in electrical shock or serious injury. All
electrical installation should be performed
by qualified personnel in accordance with
local and national building codes, fire
and safety codes, and local and national
electrical codes.
AVERTISSEMENT :
Une installation
non-conforme peut entraîner un choc
électrique ou des blessures graves. Toute
installation électrique devrait être effectuée
par un personnel qualifié, conformément
aux codes du bâtiment, aux codes incendie
et sécurité, et aux codes électriques locaux
et nationaux.
2. Attach the receiver housing to the junction
box.
a.
Align the receiver housing with the junction
box.
b.
Secure the housing in place with the
appropriate screws (not included).
3. Attach a conduit to the junction box if
needed.
NOTE:
Observe all local and national building
and safety codes.
1
Attach the junction box flush with the
mounting surface.
Ö
Attach the receiver housing to the junction
box.
Mounting Screws
Junction Box
Mounting
Holes (2)
Ceiling Box
Mounting
Holes (2)
Plaster
Ring
3
Attach a conduit to the junction box if
needed.
VoiceLift System with PVS 405D Installation Guide
•
Installation — Stage 1
18