1
Product Category
eBUS
®
Button Panel Decorator-Style Series • Setup Guide
Overview
Extron offers a range of eBUS Button Panels (EBPs) in the decorator-style form factor that can be mounted in walls or furniture
in any standard US 1-gang opening. Each panel is a fully customizable AV system control interface for use with Extron IPCP Pro
Series control processors. Individual EBPs are easily configured and can be connected with other panels to provide control for
large and complex AV systems.
NOTE:
These products are only for use with Extron UL Listed IPCP Pro control processors.
Each EBP button panel has two eBUS ports that support power and communications between the IPCP Pro control processor
and eBUS devices. Up to eight eBUS devices such as EBP button panels can be connected to the control processor and to each
other in various cabling topologies. Cabling topology refers to the physical layout of cabling interconnections between devices
in a network such as an eBUS system. eBUS systems can include daisy chain, star, or hybrid (a combination of both) system
topologies (see the
eBUS Technology Reference Guide
for basic diagrams). Every device must
have a unique identification address (eBUS ID) within the system.
Setup involves setting eBUS ID DIP switches on the EBPs, then using Extron Global Configurator
®
Plus and Professional
software, the Toolbelt utility, or Global Scripter
®
programming software, to configure the control processor. Once configured, the
AV system can be controlled from any of its EBPs.
This guide provides basic instructions for an experienced installer to install the EBP decorator-style series button panels.
For more details on the EBPs, see the
eBUS Technology Reference Guide
, available on
configuration or programming, see the software help files.
EBP Rear and Side Panel Features
Figure 1 shows the side and rear views of the EBP 105 D and the rear view of the EBP 103 D. The EBP 105 D side features are
very similar for all EBP decorator-style models except the EBP 103 D. The EBP 105 D rear features are the same for all EBP
decorator-style models except the EBP 103 D.
+V
eBUS
PWR LOAD = 1.5W
+S
-S
G
+V
+S
-S
G
A
A
B
B
EBP 105 D Rear View
PWR LOAD = X.XW
LINK
CO
M
ERRO
R
ID
ERRO
R
+V +S -S
G+
V +S -S
G
eBUS
STATUS
EBP 103 D Rear View
A
A
B
B
EBP 103 D Side View
C
C
D
D
EBP 105 D Side View
D
D
C
C
Figure 1.
EBP 105 D and EBP 103 D Rear and Side Views.
A
eBUS connectors
(2 ports) — The four-pole captive screw connectors use the Extron eBUS protocol to connect the panel to
a controller and to other panels (see
B
Status LEDs
— Provide diagnostic information about the connection, communication, and power status of the panels.
z
The EBP 103 D has amber, red, and green LEDs.
z
All other EBP decorator-style models have a single green LED.
For more information about how the LEDs are used for troubleshooting, see
C
DIP switches
— Up to eight devices can be connected to one control processor. Each device connected to the same control
processor must have a unique eBUS ID, which is set using DIP switches (see
D
Reset button
— Resets the firmware to the factory installed version (see
on the next page).
figure 1
