DXP HD 4K Series • Operation
53
Setting the Button Background Illumination — DXP 1616 Series Only
The buttons on the front panel can be set to have amber background illumination at all times
or the background illumination can be turned off.
To toggle the background illumination on and off, press and
hold
the Input 1 and Input 2
buttons simultaneously until the button background illumination changes (approximately
2 seconds.
1
2
3
4
6
7
8
9 10 11 12
14 15 16
13
INPUTS
5
1
2
3
4
6
7
8
9 10 11 12
14 15 16
13
5
OUTPUTS
Press and hold the Input 1 and Input 2 buttons
simultaneously to toggle background illumination
mode on or off.
After approximately 2 seconds, release the Input 1 and Input 2 buttons.
Figure 79.
Toggle Background Illumination On or Off
Troubleshooting
The following are recommendations for actions to take if you have problems operating the
switcher:
1.
Ensure that all devices are plugged in and powered on. The switcher is receiving power
if the Reset/Power LED is lit.
2.
Check to see if one or more outputs are muted.
3.
Ensure that an active input is selected for output on the switcher.
4.
Ensure that the proper signal format is supplied.
5.
Check the cabling and make corrections as necessary.
6.
Call the Extron S3 Sales & Technical Support Hotline if necessary.
Configuration Worksheets
Instead of trying to remember the configuration for each preset, use worksheets to record
this information. Make copies of the
for each preset configuration. Cross out all unused or inactive inputs and outputs. The
worksheet is generic for all models of DXP. Disregard or cross out boxes for inputs and
outputs that your switcher does not have.
NOTE:
The worksheet examples on these pages use a form that is set up for a
DXP 1616, you can use the same worksheet form provided on page 56 for all models
of the DXP HD 4K. Use only the input and output cells that you need to configure your
own system.