Extron electronics DVI 201xi TX, User Manual, Page: 16 / 44

DVI 201xi Tx • Installation
Installation, cont’d
2-4
Under-desk mounting
To mount the DVI 201xi Tx under a desk or podium, using the
optional Extron MBU 123 under desk mounting kit
(PN 70-212-01 ), follow these instructions:
1 . Remove rubber feet if these have been installed on the
bottom of the unit.
2 . Secure the mounting brackets to the unit, using the four
4-40 screws provided (see the figure below).
Under-desk mounting the DVI 201xi Tx
3 . Hold the unit with the brackets attached against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4 . Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6.3 mm) deep in the mounting surface at the marked
screw locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6.3 mm) of the screw head protrudes.
6 . Guide the mounting screws through the slots in the
brackets and place the unit tight against the surface of the
furniture.
7 . Slide the unit slightly in or out so that it is held in place by
the narrow part of the slots sitting on the screws; tighten
all four screws to secure the unit in place (see the figure
above).