Extron DTP T HD2 4K 230/330 • Installation and Operation
8
Power Supply Wiring
NOTES:
•
Only one power supply is required. A single power supply connected to either a
transmitter or compatible receiver can power both units.
•
Remote power is only available when the unit is set to DTP mode. When the unit is
set to HDBaseT mode, remote power and analog audio are disabled.
•
A power supply is included with each individually-packaged transmitter.
•
Do not tin the power supply leads before installing them in the direct insertion
connector. Tinned wires are not as secure in the connectors and could be pulled
out.
Figure 2 shows how to wire the connector.
SECTION A–A
A
A
Power Supply
Captive Screw
Ridges
Smooth
3/16"
(5 mm) Max.
Connector
Output Cord
Figure 2.
Power Connector Wiring
CAUTION:
The wires must be kept separate while the power supply is plugged in.
Remove power before wiring.
ATTENTION :
Les deux cordons d’alimentation doivent être tenus à l’écart l’un de
l’autre quand l’alimentation est branchée. Couper l’alimentation avant de faire
l’installation électrique.
