Revision Date:
10/16/2020
Page 7 of 28
DMP Plus Series C V / C V AT – Patton POTS
2.0
Configuring Patton POTS interface for DMP Plus Series C V (AT) VoIP
This section will guide you through the setup of the Patton POTS interface.
2.1
Ordering Information
The Patton Smart Node VoIP Gateway has multiple different models.
Note: When purchasing the Patton POTS interface, make sure to purchase the model
with FXO ports
. Units with FXS ports will not work.
2.1.1
Patton SN4112/JO/EUI - VoIP Gateway 2 FXO Ports
o
Product page:
https://www.patton.com/voip-gateway/sn4110/
2.1.2
Firmware used during testing: R6.11 2019-07-02
•
SN4110_H323_SIP_R6.11_2019-07-02
•
Firmware can be downloaded at patton.com
o
https://www.patton.com/support/upgrades/index.asp?um=S
2.2
Setting IP address on Patton
The Patton SmartNode default configuration has Interface Ethernet 0 (ETH0) set to
DHCP from the factory. The attached configuration (Patton_Config.cfg) needs to be
uploaded via the internal webpage on the Patton SN4112/JO/EUI VoIP Gateway.
2.2.1
Setting the IP address via DataViewer
Utilizing the included console cable that comes with the Patton POTS interface:
•
Connect the RJ-45 to Port labeled “Console” on the front of the Patton
•
Connect the RS-232 DB-9 to your computer
