Extron electronics CrossPoint Plus 124HV, User Manual

Page: 27 / 72

3-7 CrossPoint Plus Matrix Switchers • Operation
8. If the input button for a grouped input is pressed, and then the output
button for an output in a different group is pressed, the associated output
LED blinks twice and goes out to indicate that output cannot be tied to the
input. The associated input LED remains lit.
Example 1: Create a set of video and audio ties
See Figure 3-5 and the following steps for an example in which input 5 is tied to
outputs 3, 4, and 8.
This example assumes that there are no ties in the current configuration.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
4 8
ESC
RGBHV AUDIO
A
B
ENTER
E
3
D
5
C
B B B
F
B
LED key: = off, = on, = blinking,
= flash once
F
Press
Press Press
Press
Press
Press
Figure 3-5 — Example 1: Creating a tie
A
Press and release the Esc button. The Esc LED flashes once.
B
If necessary to select video and audio for the tie, press and release the RGBHV
and Audio buttons until the RGBHV and Audio LEDs light.
C
Press and release the input 5 button. The input 5 LED lights.
D
Press and release the output 3, output 4, and output 8 buttons. The output 3,
output 4, and output 8 LEDs blink to indicate a tentative tie.
The entire set of ties can be aborted at this point by pressing and releasing the
Esc button. The Esc LED flashes once.
E
Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now defined as video and audio input 5 tied to video
and audio output 3, output 4, and output 8.
Example 2: Add a tie to a set of video and audio ties
See figure 3-6 and the following steps for an example in which a new video tie is
added to the current configuration.
A
Press and release the Esc button. The Esc LED flashes once.
B
If it is necessary to select video-only for the tie, press and release the RGBHV
and Audio buttons until the RGBHV LED lights and the Audio LED is off.
C
Press and release the input 5 button. The input 5 LED lights. If the steps in
Example 1 have been completed, the output 3, output 4, and output 8 LEDs
light to indicate ties created in Example 1.
D
Press and release the output 1 button. The output 1 LED blinks to indicate a
tentative tie.