2 of 5
E
XTRON
C
ONFIGURATION
The CrossPoint switch must be set to 9600 baud, RS-232C (see page 3-35 of the Extron manual):
1. Using the front panel of the switch, press and hold all control buttons to enter Serial Port Configuration
mode.
2. While holding the buttons, the Control and I/O LEDs will turn on, with one in each group flashing.
3. Press and release the Enter button to set 9600 baud.
4. Press and release the RGBHV button to select RS-232.
5. Press and release an input or output button to exit serial port configuration.
6. Wait at least 5 minutes before removing power, or the settings may be lost.
As mentioned above, refer to the Extron documentation for further details.
Summary of Contents for CrossPoint 300 Series
Page 5: ...5 of 5 COMMON MISTAKES...
