HomeLogic LLC
100 Hoods Lane Marblehead, MA 09145 Phone (781) 639-5155 Fax (781) 639-9677
One
Home
Audio Integration Note
Manufacturer:
Extron Electronics
Model Number(s):
CrossPoint 300 Series Matrix Switchers
Comments:
Document Revision Date:
9/5/06
O
VERVIEW AND
S
UPPORTED
F
EATURES
T
HE FOLLOWING FEATURES ARE SUPPORTED
:
Traditional Matrix Switcher:
The CrossPoint 300 switches are multizone - multisource audio / video
switchers that can be controlled by the
One
Home software using an RS-232 port. The
One
Home Viewer
interface can be used to select sources in each zone.
Standard Configurations:
The CrossPoint series driver will switch audio and video to a zone together. In
other words, if zone 1 is playing
Audio Source 2
, then
Video Source 2
will also be routed to zone 1.
T
HE FOLLOWING FEATURES ARE
NOT
SUPPORTED
:
Independent Audio / Video Switching:
The CrossPoint series switches generally allow you to send
Audio Source 1
to zone 2, and
Video Source 1
to zone 3. This is not supported in the
One
Home
system:
Audio Source 1
and
Video Source 1
will switch together.
Volume Control:
Volume control is currently not supported for the CrossPoint series: in typical
configurations to date there is a receiver or other amplifier which performs this function. Please contact us
if you would like to have volume control.
I
NSTALLATION
O
VERVIEW
1. During the rough-in phase, install wires for the sources, amplifiers and displays for each zone.
2. Also during the rough-in phase, run a Cat5 wire from the location of the switch back to the Network
Assembly of the
One
Home system for RS-232 communications. Refer to the
RS-232 Connection
Options
Integration Note for other options.
3. Install the switch, the sources, amplifier, displays and speakers.
4. Setup the switch to operate according to Extron standard procedures: see
Extron Configuration
below.
5. Confirm proper audio and video switching as configured in step above.
6. Connect the
One
Home system to the switch electrically. See the wiring diagrams for more
information.
7. Configure the
OneHome
system
for the switch and confirm communication between the switch and
the
Home
Brick.
8. Test the system by changing sources in a zone to confirm the correct source plays and volume is
controlled. Test source control for any sources that are to be controlled from the
One
Home interface.
Summary of Contents for CrossPoint 300 Series
Page 5: ...5 of 5 COMMON MISTAKES...
