7
Vertical or angular mounting
The included brackets must be installed diagonally in the enclosures as shown below.
Cable Cubby 1402
Side View
Angular
Mounting
Vertical
Mounting
Retractor Configuration for Cable Cubby 1402
Horizontal mounting
Install the brackets as shown below.
NOTE:
Retractors may also be mounted using the Quad Bracket (see
for part numbers).
Cable Cubby 1402
Side View
Horizontal Mounting
Installing Retractors
Follow the steps below to install Retractors. For horizontal or angular Retractor
mounting, see the information at
right, then follow the steps below.
Insert the pin through the
Retractor mounting hole on
the side of the Cable Cubby
and Retractor assembly.
Secure the clip
on the pin.
Insert Retractors into
the Retractor bracket.
Secure the locking screw
on each Retractor. Do not
overtighten.
2
1
4
3
p
Pin
Clip
Angular Mounting
Remove the enclosure screws as shown above, then
follow this step:
Horizontal Mounting
See the
Cable Retractor Series/2 Setup Guide
, available
on the Extron website, for additional steps.
Remove two enclosure screws
(one on each side) from this position.
Then, mount the Retractors as shown
at left.
Cable Release
Assembly
Move the cable release assembly upward until
the angular mounting hole is visible. Reinstall the
enclosure screws in this hole (both sides).
Remove two enclosure screws
(one on each side) from this position.
Then, mount the Retractors as shown
at left.
Cable Release
Assembly
Move the cable release assembly upward until
the angular mounting hole is visible. Reinstall the
enclosure screws in this hole (both sides).
Top View
Top View
