3-7
Annotator • Front Panel Operation
3
.
Press the Next button to go to the next setting. If necessary repeat pressing
Next until the desired level is attained. Refer to the table below for adjustable
settings for each signal format.
Input Format
RGB YUVp/
HDTV
RGBcvS
YUVi S-vid
DVI
SDI
HD-SDI
Film Detect
X
X
X
X
X
X
X
X
H Start
X
X
V Start
X
X
Pahse
X
X
Total Pixels
X
X
Active Pixels
X
X
X
X
X
X
X
Active Lines
X
X
X
X
X
X
X
Figure 3-4 — Adjustments possible per signal format
4
.
At the desired setting (for example, Horizontal Start on
input #2 with a YUVp/HDTV signal), rotate the right adjust
knob (
{
) to adjust the settings value as desired (here to 122).
5
.
Repeat steps 3 and 4 for each setting as desired.
6
.
When complete press Menu once or Next repeatedly to return to the top level
menu. Alternatively, allow to time out to return to the default cycle.
Output configuration
Within this menu an outputs resolution, refresh rate, output signal type, and sync
polarity can be selected and adjusted. Refer to the table below for applicable
resolution and refresh rates.
1
.
Press Next to bring up the Resolution submenu. In this submenu, the
resolution and refresh rate can be adjusted.
2
.
Rotate the left front panel encoder (
[
) to adjust the resolution value, and
rotate the right encoder (
{
) to adjust the refresh rate.
.
Input #2
Horz Start 122
