4
Option 2: Cable Pass-Through Module
Secure the grommet
plate on the connectivity
bracket, using four of the
provided module screws.
2
Insert cables through the
bottom of the connectivity
bracket and into the holes
of the grommet plate.
Snap the included
hole plugs into
any unused holes.
1
3
Insert “Show Me”
Cables into the
grommet plate.
1
Attach the “Show Me” Cable Trim Plate
to the top of the module, using the
module screws.
2
Attach the grommet
plate to the bottom
of the module, using
the module screws.
3
Option 3: Retractor Bracket
Secure the bracket using four of
the provided pan-head mounting
screws with star washers. Tighten
the screws using a screwdriver.
Insert the bracket as shown.
The bracket may be installed on the left
or right side of the enclosure and at the
lowest height.
2
1
left
the
Preparing the Cable Cubby
Step 1 (Only for multiple enclosures) — Assemble Enclosures
Option 1: AAP Module
Secure up to three single-space
AAPs in the AAP plate.
Secure the AAP plate on the connectivity brackets,
using four of the provided module screws.
#4-40 Nut with
Captive Washer
Insert cables through the bottom of the connectivity bracket.
Connect cables to the AAPs.
1
3
2
Step 2 — Assemble Connectivity Modules
Connectivity modules allow you to populate the Cable Cubby enclosure with a combination of AAPs, cable pass-through, or
Retractors. Follow the steps below to assemble the connectivity modules of your choice.
Using a #2 screw driver,
unscrew the four pan-head
screws that attach the enclosure
sides of the Cable Cubby together.
Repeat this step on the corresponding
side of the other enclosure.
Detach side panels of both enclosures.
1
Before attaching the enclosure, ensure the
keyhole mounting holes are orientated in the
same direction.
Attach the enclosures together
with the four pan-head mounting screws
and washers that were removed in step 1.
2
Repeat steps 1 and 2 to
add more enclosures to
the extension.
3
NOTE:
The opening of the bracket should be
installed towards the outside of the enclosure.
